SPORTEC® shooting & shooting pro

Protection over floors, walls and ceilings of indoor shooting ranges

Shooting range

Shooting range

SPORTEC® shooting

For optimum protection in shooting ranges

Specifically designed as a projectile-absorbing surfacing material, SPORTEC® shooting provides protection over floors, walls and ceilings of indoor shooting ranges and nearby outdoor facilities. SPORTEC® shooting reliably absorbs dangerous ricochets and rebounds as documented by independent test reports. The material's remarkable elasticity makes bullet holes practically invisible after absorption. SPORTEC® shooting slabs installed on floors could be covered. It provides a seamless surface which can be easily cleaned of gunpowder deposits. On walls and ceilings this coating is normally not required.


SPORTEC shooting rot

Technical Data

Material
Recycling tyre rubber granules bonded with polyurethane elastomer.
Type of floor covering
Safety surface
Thickness(es)
40 mm (± 2 mm)
Length x width
500 mm / 500mm (± 0.8 %)
500 mm / 1000mm (± 0.8 %)
Shooting protection
Tested and conformed the requirements,
according Shooting Safety Institute Munich / Germany,
Test report No. B-31/2009
Energy range
Up to 10,000 J (German marksman union guidelines)
Military, police and civil shooting ranges

Downloads

Data sheet PDF
Installation instruction PDF

SPORTEC® shooting pro

Specifically designed as a projectile-absorbing surfacing material, SPORTEC® shooting provides protection over floors, walls and ceilings of indoor shooting ranges and nearby outdoor facilities. SPORTEC® shooting reliably absorbs dangerous ricochets and rebounds as documented by independent test reports. The material‘s remarkable elasticity makes bullet holes practically invisible after absorption. SPORTEC® shooting slabs installed on floors should be covered with an appropriate fireproof PU coating. It provides a seamless surface which can be easily cleaned of gunpowder deposits. On walls and ceilings this coating is not required.


SPORTEC shooting rot

Technical Data

Material
Recycling tyre rubber granules bonded with polyurethane elastomer.
Type of floor covering
Safety surface
Thickness(es)
45 mm (± 2 mm)
Length x width
500 mm / 500mm (± 0.8 %)
500 mm / 1000mm (± 0.8 %)
Shooting protection
Tested and conformed the requirements, according Shooting Safety Institute Munich / Germany, Test report No. 15M066A01
Energy range
1500 - 7000 J (VPAM ARG 2012-2)
Open and closed shooting ranges, official and civilian use.
200 - 1500 J (VPAM ARG 2012-2)
Shooting ranges, official and civilian use.

Downloads

Data sheet PDF
Installation instruction PDF
Applications of this product